Publicidad
Idiomas disponibles
Idiomas disponibles
SUSPeNSION MOUNTINg
13b
Depending on mounting location,
install 4 toggle bolts into drywall
or 4 hook screws into wood.
NOTICE: Toggle bolts are not considered an acceptable means
of support in Canada, in accordance with CSA C22.2 No. 250.4.
NOTICE: There are many installation applications to
suspension mount the fixture. Installer is responsible to ensure
mounting accessories and hardware are compatible with
attachment method to surface or structure in accordance with
any local code requirements for installation and inspection.
14b
Attach the aircraft cable to the toggle bolts or hook screws.
ADJUSTINg THe cOLOr TeMPerATUre AND BrIgHTNeSS OF THe LIgHT:
This fixture allows you to customize the color temperature of the light using four settings from soft white to daylight.
• Choose your favorite correlated color temperature (CCT) from four options: 3000K soft white, 3500K neutral white, 4000K cool white, or 5000K daylight.
• Move the toggle switch on the back side of the fixture to make your selection before inserting the fixture into the ceiling.
NOTE: The factory setting for correlated color temperature (ccT) is 4000k, which is cool white.
• Choose the desired brightness (lumen output) from four options: 2500lm, 3125lm, 3750lm or 4375lm.
• Move the toggle switch on the back of the fixture to make your selection before pushing the fixture into the ceiling.
NOTE: The factory setting for brightness (lumen output) is 4375lm.
SeLecTINg WOrkINg MODe
This fixture allows you to choose between three working modes by using your wall switch and flipping it on/off/on within 3 seconds.
TO TURN ON WHOLE SYSTEM: Turn on the light switch to activate the light fixture with green indicator light and disinfection mode.
TO TURN ON DISINFECTION MODE ONLY: Turn off the main down light by wall switch, and turn back on within 3 seconds to active the disinfection only mode.
TO TURN ON THE MAIN LIGHT: Turn off the main light by wall switch, and turn back on within 3 seconds to active the main light only mode.
cLeANINg THe FILTer
• When the air volume reduces, remove the filter to clean it.
• Press the small cover slightly with the finger.
A
B
• After opening the front gear panel, first unplug the ground wire terminal at point A,
and then remove the safety rope at point B.
AA
• Use a cross head screwdriver and remove the
screws in the small square groove.
Quick Cable Lock
AA
Mounting Clips
Bend each of the mounting clips on the back of the fixture upward.
15b
Connect the mounting clips to the aircraft cables by using S hooks.
Adjust the aircraft cables to level the fixture.
NOTICE: The LED flat panel must hang a minimum of 3 in. from
the ceiling.
Make the electrical connections. See Making Electrical
16b
Connections.
Restore power at the electrical panel.
17b
Turn on the light switch to activate the fixture.
• Keep the small cover at 90 degree to the panel, pull the
back of the small cover and then pull out the front panel.
• Remove the filter from the front panel and then pull it back.
A
Publicidad
