Technical Information - Zzipp ZZBUBBLE Manual De Ususario

TECHNICAL INFORMATION

LEDs gradually decline in brightness over time, primarily due to heat. Packaged in clusters,
LEDs exhibt higher operating temperatures than in ideal, single—LED conditions. For this
reason, using clustered LEDs at their fullest intensity significantly reduces the LEDs' lifespan.
Under normal conditions, this lifespan can be 40,000 to 50,000 hours. If extending this lifespan
is vital, lower the operating temperature by improving the ventilation around the product and
reducing the ambient temperature to an optimal operating range. In addition, limiting the
overall projection intensity may also help to extend the LED's lifespan.
Do not allow the ZZBUBBLE to become clogged due to the sticky bubble fluid. Cleaning and
maintenance are necessary.
The recommended cleaning procedure is as follows.
1) Unplug the product from power.
2) Empty bubble fluid from the machine.
3) Add water to the bubble fluid tank.
4) Connect the product to power and allow it to warm up. Run the Cleaning Mode through Menu
or DMX. Thoroughly rinse the Bubble fluid reservoir.
5) Run the product in a well-ventilated area.Do not allow the pump to run dry.
6) Excessive dust, fluid residue and dirt will degrade performance and cause overheating.
Remove dust from air vents with air compressor, vacuum or soft brush. The casing could be
cleaned by the damp cloth
7) Restore the hoses and cap. Store the unit until next use.
Note : The default cleaning time is 1 minute. Without turning of the cleaning mode
Test— run your ZZBUBBLE on a monthly basis to achieve the best performance.
Before storing the machine, clean it as described in the cleaning procedure above; however,
only follow steps 1 through 5.
Do not refill the tank with fog fluid if storing the machine. Empty both the bubble and haze fluid
tank. Cleaning the system prior to storage will help prevent any particles from condensing
inside the pump or heater while not in use.
8