Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the locking cylinder
–
Insert springs
E
.
Tip
The locking cylinder comes with many small parts.
It is recommended that you perform the assembly
while seated at a table.
502241-01
–
Insert wafers
A
bers
,
502242-01
–
Insert the key and check whether the tumblers with the
number 1 are correct.
Guideline
The tumblers must close flush with the locking cylinder.
–
Replace the non-matching tumblers with ones that have
the matching number.
Tip
It is recommended that you note the numbers of
500517-01
the matching tumblers so that the subsequent
locking cylinders can be equipped immediately.
–
Repeat the steps for chambers
first six chambers are fitted with the correct wafers.
–
Insert the key.
Guideline
The tumblers must close flush with the locking cylinder.
500518-01
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert locking cylinder as shown.
The engaging plate
Engaging plate
502243-01
bo
(included) into chambers
bn
(included) with the number 1 into cham-
C
E
, and
.
B
D
,
6
(included).
p. 17)
bp
points downward.
bp
engages.
ASSEMBLY 5
A
C
,
, and
F
, and
until the
11
Publicidad
