Publicidad
Idiomas disponibles
Idiomas disponibles
2. Put the product on the ground and install the
transport guard (A) to the cutter.
A
3. Move the angle adjustment lever (B) away from the
attachment to remove the pin (C) from its hole.
B
Note:
It the pin does not move smoothly, move the
shaft (D) back and forth a little.
4. Use the angle adjustment handle (E) to adjust the
angle of the cutter.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
8
D
C
E
Maintenance
5. Release the angle adjustment lever to lock the pin
(C) in its correct hole.
C
1917 - 001 - 18.07.2022
Publicidad
