Final Installation; Front Side - Furrion CHILL FACR13LPSA-PS Manual De Usuario

2. Connect the harness function according to the
OneControl® instructions.
3. Connect freeze sensor.
Clamp
Freezer sensor
Freeze Sensor Cable
Rooftop Unit Cable
Room Sensor Cable

Final Installation

1. Tuck/secure LED cable (white strip, tagged with "LED") out
of the way. This wire is reserved for lighting options.
LED Cable
2. Install the Air Distribution Box (ADB) shroud over the
mounting frame and fix with the 4 provided long screws, or
#8 x1.5" (max) pan head RV screws can also be used.
NOTE: Make sure the "THIS WAY FRONT" mark is facing
front (the direction of the vehicle) while installing.

Front side

115VAC
Power Cord
3. Align the filter tabs with mating notches and push to snap
the filters into the ADB shroud.
Front side
4. Install the screw caps to cover the screw holes.
Screw Cap
Your new rooftop air conditioner has now been fully installed in
the RV roof.
- 10 - CCD-0007273 Rev: 11-04-22