Care And Maintenance - Perel GIKLED03 Manual Del Usuario

GIKLED03
4. Operation
4.1 Introduction
This insect killer uses a UV light to attract flying insects. The fan will suck these insects
into the container and dry them. This insect killer does not produce any noisy electric
shocks nor does it emit any toxins, smoke, scent or radiation.
This insect killer is designed to be used outdoors (garden, terrace...).
4.2 How to Use
1. Install the insect killer on a stable and non-slippery surface or hang on a height of
50-100 cm above the ground.
2. Connect the insect killer to the power source.
3. Disconnect from the power supply after use.
For best results, turn off other light sources and prevent from installing the appliance in
the draught.
5. Troubleshooting
Appliance does not start
Appliance does not light
6.

Care and Maintenance

Storage
Store the appliance and its accessories in a clean and dry area.
Cleaning
The cleaning frequency depends on the intensity of use. Check the tray of the device at
least once a week. Clean more often if necessary.
Before starting any cleaning or maintenance activities, unplug the appliance from its
power source, wait for 5 minutes and let it cool down.
Wipe all exterior surfaces of the appliance clean with a soft cloth dampened with a soap
and water solution. Do not immerse or submerge any part of the appliance in water or
any other liquid. Never use solvents or cleaning agents containing petroleum (petrol,
kerosene, oil), paint thinner, turpentine, alcohol, or ammonia.
Problem
Noisy fan
Reason
Power supply not
connected well
On-off button not pressed
Power supply not
connected well
Light is damaged
PCB board is damaged
Foreign objects in the fan
4
Possible solution
Reconnect the power
supply
Press the on-off button
Reconnect the power
supply
Light source cannot be
replaced; scrap the
appliance
PCB Board cannot be
replaced; scrap the
appliance
Clean the fan