Main Power Switch - Makita GML01 Manual De Instrucciones

Main power switch

WARNING:
Always turn off the main power
switch when not in use.
To turn on the machine, press the main power switch.
The main power lamp lights up in green. To turn off the
machine, press the main power switch again.
NOTE: If the main power lamp lights up in red or
blinks in red or green, refer to the instructions for
machine/battery protection system.
NOTE: This machine employs the auto power-off
function. To avoid unintentional start up, the main
power switch will automatically shut down when the
switch lever and drive lever (if equipped) are not
pulled for a certain period after the main power switch
is turned on.
Mode switching button
You can switch the operating mode by pressing the
mode switching button. When the machine is turned on,
the machine starts up in the normal mode.
Refer to the table below for each mode.
Mode Lamp
Normal mode Both the soft
no-load mode lamp
and noise reduction
mode lamp are off.
Soft no-load The soft no-load
mode mode lamp lights up
in green.
Noise reduction The noise reduction
mode mode lamp lights up
in green.
Switch action
WARNING:
Before installing the battery car-
tridge, always check to see that the switch lever
actuates properly and returns to the original posi-
tion when released. Operating the machine with a
switch that does not actuate properly can lead to loss
of control and serious personal injury.
NOTE: The mower does not start without pressing the
switch button even the switch lever is pulled.
NOTE: Mower may not start due to the overload
when you try to mow long or dense grass at a time.
Increase the mowing height in this case.
This machine is equipped with the switch button. If you
notice anything unusual with the switch button, stop
the operation immediately and have it checked by your
nearest Makita Authorized Service Center.
1. Install the battery cartridges, and then close the
battery cover.
2.
Press the main power switch.
NOTE: The main power lamp blinks in green if you
press the main power switch while pulling the switch
lever. Release the switch lever before pressing the
main power switch.
3.
down the switch button. Release the switch button when
the motor starts running.
► 1. Switch button 2. Switch lever
4.
forward and hold it to drive the rear wheels.
Description
The machine works
in the normal mode.
You can minimize a
start-up shock and
start the machine
smoothly.
You can decrease
the noise at mowing.
► 1. Drive lever
5.
stop the machine.
12 ENGLISH
Pull the switch lever toward you while holding
1
Fig.21
While holding the switch lever, push the drive lever
1
Fig.22
NOTE: You can drive the rear wheels by pushing
the drive lever forward and hold it without pulling the
switch lever.
Release the drive lever and the switch lever to
2