Operation - Klarstein 10029344 Manual Del Usuario

Operating panel
Bottom power switch
1. Press Power switch which is in the back of the device, the device enters into energized state, and the
heater is ready to use with a Bi sound, now all the functions and displays are off.
2. In energized state, all the pressing are invalid except
it again, the device enters into standby mode. There are following situation when in working condition.
During operation the following functions are available:
Shift between low power (1600 W) and high power (2500 W).
Operated at low heating power: low heating power indicator
Operated at high heating power: Middle heating power
In working condition, press this key to make the device swing or not.
Press Swing: the device will oscillate, and the indicator will be on.
Press Swing again: the swing function turns off, and the indicator will be off.
Setting the time (press this key once in working condition)
1x
• The time indicator
press the "UP (+)" and the "DOWN (-)" key to set the timer (within a range of 1-12
hours), the timer will add or subtract 1 h with every press.
• Enter into the timer setting mode, the timer that has been set before can not be
changed. You can reset the time, only when pressing „UP (+)" and „DOWN (-)" key.
• If the timer turns to value 0, then the device will turn off at once, and enter into stand-
by mode.
• Press SET key, the timer setting is finished, and enter into temperature setting.
15

Operation

operating panel schematic diagram on top
key. Press
will be on. The light will flicker twice per second. At this time
key, the device starts working. Press
on.
on.