Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP & BASIC OPERATION
Essential Setup
1. Unpack the unit and remove all packaging materials.
2. Place the unit on a flat and level surface. The selected location should be stable and free from
vibration.
3. Plug the power adaptor into the electrical outlet and connect other end to the back of the unit.
4.
Press the
Button on the upper right corner of the front panel. The display will light up in
amber background, and the playback mode will appear on the display.
5.
When the unit is playing music, the playback message will appear on the display.
To Open Turntable Cover:
1. Lift the turntable cover all the way up until it stops.
2. Lower the cover slowly until the latch engages. If the latch
does not engage, pull the lower bar by hand.
3. The cover will now stay open.
To Close Turntable Cover:
1. Lift the cover all the way up until it stops.
2. The latch should disengage and you may now slowly lower the cover.
If the latch does not disengage, push out the lower bar by hand.
3. Make sure you hold the cover to avoid pinching your fingers as it closes.
Common playback control
● Press the PLAY/PAUSE button to pause / play the playback.
● Press the
● To search for a part of track: press and hold the
part you want is found.
● Search for a folder, press the Item Up/Down buttons to choose the folder.
● Press the STOP/PAIR button to stop playing.
Note: These controls do NOT always function in specified playback mode.
Repeat function
Press REPEAT button: ● one time, to repeat the current track.
Note: This feature functions in CD and USB mode.
Program function
This function enables you to set the playback of tracks into an ordered playlist.
1. Press the STOP button; then press the PROG/MEMORY Button to activate the program
feature. The display will show "MEMORY", "P01" and blinking "00".
2. Press the
3. Press the PROG/MEMORY button again to confirm.
4. Repeat the above steps to program other tracks.
5. After finished, press the PLAY/PAUSE button to start playback.
6. Press the STOP button once to stop.
7. Press the STOP button twice to erase the programmed track, and "MEMORY" will disappear
from the display.
Note:
● This feature functions in CD and USB mode.
● This unit can program up to 20 tracks.
● Turning the power off or switching to other playback modes by turning the Function Knob will
automatically erase the programmed playlist.
or
button to skip to next or previous track.
● two times, to repeat the current folder.
● three times, to repeat all tracks of the disc.
● four times, to cancel the repeat function.
or
button to select your track.
or
button and release it when the
8
Publicidad
