Disposal And Recycling - nuair TALENTO Manual De Instrucciones

9. DISPOSAL AND RECYCLING

G
B
Pursuant to Directive 2012/19/EU on waste
electrical and electronic equipment (WEEE).
The symbol carrying a crossed-out refuse container depicted on any
equipment or the relative packaging means that, at the end of its useful
life, said product must be disposed of separately from other waste.
The user must therefore take said equipment to the centres
specialising in differentiated refuse collection of electric and electronic
equipment or alternatively return it to the reseller when purchasing a
new similar piece of equipment.
Thanks to differentiated refuse collection, discarded equipment can
be sent to be recycled, treated and disposed of in an environmentally-
friendly manner; this helps avoiding possible negative effects on the
environment and on health and promotes the re-employment and/or
recycling of the equipment's materials.
Any unauthorised disposal of the product by the user will result in the
application of the fines provided for by the regulations in force.
10. POSSIBLE FAULTS AND RELATED PERMITTED REMEDIES
Fault
The compressor stops and restarts
automatically after a few minutes.
After a few attempts to restart, the
compressor stops.
The compressor does not stop and the
safety valve is tripped.
Any other type of operation must be carried out by authorized Service Centers, requesting original parts. Tampering
with the machine may impair its safety and in any case make the warranty null and void.
Warranty and repair.
In the event of defective goods or requirements for spare parts, kindly contact the sales point where you made your purchase.
Cause
Tripping of the thermal cutout due to
overheating of the motor.
Tripping of the thermal cutout due to
overheating of the motor (removal of the
plug with the compressor running, low
power voltage).
Irregular compressor operation or pressure
switch malfunction.
22
Remedy
Allow the compressor to cool down.
Ventilate the work area.
Activate the I/O switch (On/Off). Ventilate
the work area. Wait a few minutes. The
compressor will restart independently.
Remove the plug and contact the Service
Center.