Publicidad
Idiomas disponibles
Idiomas disponibles
˜ Troubleshooting
Problem
Product does not work. Power supply interrupted.
Product does not
operate with full
power.
Poor performance.
Extensive dust
formation.
Possible cause
Power cord or power plug
defective.
[
34 ]
Carbon brushes
worn out.
Other electrical defect.
Extension cord too long and/or
cross-section too small.
Voltage of the power supply
(e.g. generator) too low.
Sandpaper worn out.
2 ]
[
Sanding pad
worn out.
7 ]
[
Brush edge
worn out.
External dust extraction unit not
connected or switched off.
Solution
Check the socket-outlet by connecting
another electric appliance.
15 ]
[
Have the product repaired by a
qualified specialist.
Replace the carbon brushes
(see "Main tenance").
Have the product repaired by a
qualified specialist.
Use an extension cord with
permissible length and/or adequate
cross-section.
Connect the product to an appropriate
power supply.
Replace the sandpaper.
Have the sanding pad replaced by a
qualified specialist.
Have the brush edge replaced by a
qualified specialist.
Connect or switch on external dust
extraction unit.
[
34 ]
GB/MT
89
Publicidad
