Charging; Support Base And Wall Mounting - G3 Ferrari G90027 Manual De Uso

the air re-emitted from the cleaner will be more healthy and clean. To maintain the
performance of the vacuum cleaner is recommended to clean the filters regularly.
- Press the release button to remove the dust container (8) and separate the container
from the unit (Fig.2).
- Remove the filter (7) by pulling it toward you.
At least once a week, shake the HEPA filter in the bin to get the dirt out.
At least once every 2 months, carry out a more thorough cleaning: rinse HEPA filter
and plastic support and clean container with a damp cloth and DRY ALL PARTS
THOROUGHLY. CAUTION: when the filter (7) runs out, contact an Authorized
Service Center for replacing it.

CHARGING -

original adapter (12). Charge can be effected only through the charge base (11).
If the power adapter is damaged or get lost, contact an authorized service center; it is recommended not to use
other adapters which may damage the battery and impair the functionality of the appliance.
When the charge is about to run out, the indicator light (2) flashes blue. When finished, the light flashes
alternating blue and red. In these cases it is necessary to recharge.
For charging, switch off the product, plug the adapter to the power outlet and place the vacuum cleaner in its
housing in the charging base (11).
The light (2) flashes red if the device is correctly connected to the adapter. When fully charged (about 4.5
hours) the light turns blue.
WARNING: The following measures will preserve the battery life.
- When you first use the unit, and for following uses, complete charge is of 4.5 hours.
- ALWAYS charge and discharge completely the battery. NEVER leave battery uncharged: if the appliance
is exhausted immediately proceed to charging. Do at least one charge every month.
- WARNING: if you store appliance on its support, connect the adaptor to the electric socket ONLY when
you want to charge the appliance. When charging is finished unplug the adaptor.
Battery has a limited duration. When the battery duration is shorter the charging time gets longer. If the
battery is weak even after a complete recharge, it means that its lifetime is nearly finished and that replacing it
is needed. In this case contact an authorized after sales service.

SUPPORT BASE AND WALL MOUNTING

The device is supplied with a multifunction support (11). This accessory must be
used for recharging, but it is also very convenient for storing vacuum cleaner and
accessories in order. It can also be used in 2 configurations: placed on a surface or
mounted on the wall.
SUPPORT BASE ON A SURFACE
Assemble the two parts of the charging base as shown in Fig. 4, place the charging base on a stable surface
and arrange the product and accessories in their respective housings.
WALL MOUNTING
Assemble the two parts of the charging base as shown in Fig. 5, place the support on the wall in the place
where you want to store the vacuum cleaner. In the upper part of the support there are 2 holes; with a pencil
mark the wall in correspondence of these holes, and check that the marks are 9.5cm apart.
ATTENTION: the mounting point of the wall support must be close to a suitable electrical
outlet, so that it can be reached easily with the supplied adapter.
ATTENTION: make sure that there is no passage of hydraulic pipes or electric cables in the
points where you are going to drill the wall.
With a drill, make 5mm holes in correspondence with the marks, and insert appropriate plugs.
Screw the screws into the plugs, leaving the screw protruding for about 6mm, then insert the holes
of the support on the screws and slide the support down to lock it. Arrange the product and accessories in the
slots.
CAUTION: to recharge the unit, use only the supplied
12