Li-Ion Battery State Of Charge Display; Technical Data - Hilti SBT 4-A22 Manual De Instrucciones

3.3

Li-ion battery state of charge display

The charge state of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge state of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
3.4 Items supplied
Drill / driver, operating instructions.
• Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

4.1 Drill/driver
Rated voltage
Weight in accordance with EPTA Procedure 01 including B22⁄8.0 battery
Speed
Torque (soft joint)
Torque range (15 settings)
Ø keyless chuck diameter range
Ø drill bit (metal)
Ø drill bit (hardwood)
Ø drill bit (softwood)
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
*2184701*
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is completely dis-
charged.
The power tool is overloaded or has overheated.
2184701
21.6 V
3.1 kg
1st gear 0 /min ... 370 /min
2nd gear 0 /min ... 2,140 /min
≤ 50 Nm
2 Nm ... 12 Nm
1.5 mm ... 13 mm
1.5 mm ... 13 mm
1.5 mm ... 20 mm
1.5 mm ... 32 mm
English 17