Preparations At The Workplace; Inserting The Battery - Hilti SBT 4-A22 Manual De Instrucciones

Noise emission values
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound (power) level (L
WA
Uncertainty for the sound power level (K
Total vibration
Vibration emission value for screwdriving (a
Uncertainty for screwdriving (K)
Drilling in metal (a )
h,D
Uncertainty for drilling in metal (K)
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting and adjusting the side handle
CAUTION
Risk of injury by accidental starting!
▶ Make sure that the forward / reverse switch is in the middle position (switch-on interlock engaged) or that
the battery has been removed from the drill / driver.
▶ Fit or adjust the side handle.
5.5 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
18 English
)
pA
)
pA
)
)
WA
)
h
2
75 dB(A)
3 dB(A)
86 dB(A)
3 dB(A)
< 2.5 m/s²
1.5 m/s²
< 2.5 m/s²
1.5 m/s²
2184701
*2184701*