Using The Buttons And Display - Samsung VS20A95 Serie Manual Del Usuario

Operation

Using the buttons and display

NOTE
• Only the + button works when the vacuum cleaner is in the 'WET' mode.
• You cannot enter the language settings when the vacuum cleaner is in the 'WET' mode.
• The Energy Saving mode is automatically disabled if you use the vacuum cleaner.
• The brush may cling to the floor or does not turn properly depending on the floor material (a carpet, a
mat, bedding, etc.). If such a problem occurs, change the suction power mode to 'MIN or MID' .
Alert messages
Message
Low battery
Object stuck in brush/tool
Filter not inserted
Clogged
Check brush, tool, or filter
Clean Micro filter
Energy Saving on
Energy Saving off
16 English
01 Display
- Displays the current mode ('MIN, MID, MAX, JET, or WET') or the
alert message.
02 Power ( )
- Press this button to turn on or off the vacuum cleaner.
- When you turn on the power, the vacuum cleaner starts in the 'MID'
mode.
- If you assemble the Spray Spinning Sweeper, the vacuum cleaner
starts in the 'WET' mode.
03 Suction power control (+ / -)
- You can change the suction power mode ('MIN, MID, MAX, or JET').
- In the 'WET' mode, press the + button to spray water once or press
and hold the + button to spray water for up to 2 seconds.
- Press and hold the + button for 3 seconds to enter or exit the
language setting. Press the + or – button to select a language.
- While the vacuum cleaner is on the Clean Station, press and hold the
+ button for 5 seconds to enable or disable the Energy Saving mode.
Displays when battery is low.
Error displays when something is caught in the brush or tool.
Error displays when Micro Filter is missing.
Error displays when the vacuum cleaner is clogged.
Alerts the user to check the brush, tool, or filter in order to
solve the clogging error.
Alerts and recommends the user to regularly check and wash
the Micro Filter. (Refer to the 'Cleaning the vacuum cleaner'
section.)
Displays when the Energy Saving mode is on.
Displays when the Energy Saving mode is off.
Explanation