HOGERT HT4M322 Instrucciones De Uso página 11

The device assumes three ways of measuring distance using Pythagoras' theorem. Press the key
select the measurement mode.
Measure the counter-angle a and perpendicular b, indirectly you can calculate the value of height h.
Press the key
, to measure a counter-angular triangle. Then the next border will flash. After the targeting and
measurement is done with the
main display area, the measured results a and b are displayed in the auxiliary display area.
Measure the anti-rectangular a, c and rectangular b,and then indirectly calculate height h.
Press the key
a of the triangle. The rectangular b line begins to flash. Aim, press the key
Repeat the operation to measure the counter-angle c. The device will automatically calculate the height h
and the calculated results will be displayed in the main display area, while the measured results a, b and c
will be displayed in the auxiliary area.
Measure the counter-angle a, b and rectangular c and calculate the value h indirectly.
Press the key , until it appears on the screen
to measure the counter-angular triangle a. Repeat the steps and measure the distance b. Start the next
measurement when rectangular c starts flashing. The device will automatically calculate side h and the
calculated results will be displayed in the main display area, while the measured results a, b and c will be
displayed in the auxiliary display area.
Note:
In Pythagorean measurement mode, the rectangular length must be smaller than the anti-rectangular
length. Otherwise, an error message will be displayed. In Pythagoras measurement mode, to ensure
accuracy of measurement, start from the same starting point.
• Addition and subtraction of measurements
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
and the icon on the screen starts flashing
the height h is automatically calculated. The results are displayed in the
, until the screen blinks
. After aiming the laser, press the
. Aim and press the key
which will start flashing. Aim and press
to measure the counter-angle
, to measure the distance.
, to
,
11