Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CAUTION! When selecting a combination do not use birthday, phone number or other
predictable data that could give correlation between the user and combination. Once the
new combination has been set, do not share the combination. It is a secret.
Valid Combination Entry - Double signal after valid 6 digit combination is entered.
Invalid Combination Entry - Triple signal indicates the old combination is still valid.
3. Keypad backlight
• Press either lightbulb icon
• Panel keys will remain lighted for approximately 8 seconds
• The backlight feature will not adversely affect battery life if done in conjunction with
normal anticipated keypad usage.
4. Low battery warning
• Repeated LED flashing and beeping during an opening indicates that the battery is low
and needs immediate replacement.
• Uses a 9-Volt alkaline battery only.
The replacement of batteries at least once annually is recommended.
If battery is depleted and will not allow lock to open, follow instructions below. Lock
contains a non-volatile memory. Even with batteries removed, the lock will retain all
programming.
Replacing the batteries
1. Slide the keypad housing up and carefully pull away from mounting surface to expose
battery compartment.
2. Remove the old 9-Volt alkaline battery from the battery compartment.
3. Remove the connector by unsnapping it from the two terminals on the top of the battery.
CAUTION! Hold on to battery terminal connector to avoid pulling the wires out of housing.
4. Press and hold the "0" key for 10 seconds before installing a battery.
5. Connect a new 9-Volt Alkaline battery to the battery clip.
6. Gently place the battery and the leads completely into the battery compartment.
7. Carefully position the keypad over the mounting screws and slide the keypad housing
down. Ensure there are no wires or cables trapped between the input pad and the safe door.
Pinched cables can result in a short circuit.
NOTE: The audit features, the software features, features associated with peripheral devices
and systems, optional interconnect devices and their associated features, features involving
the use of user keys, the duress feature, monitoring features, remote features, and other
additional features have not been evaluated by UL. Models 8130 and 3190 keypads are not
certified by UL, are not UL listed, and not approved for UL applications.
6
Publicidad
