Uline TORNADO H-10166 Manual De Instrucciones página 6

CLEANING BRUSH/REPLACING DRIVE BELT
Check rotating cleaning brush and drive belt regularly
for wear or damage.
NOTE: Keep rotating cleaning brush ends free
of string, hair and carpet fibers.
NOTE: The rotating cleaning brush can most
often be cleaned without removal from the
vacuum. If there is an excessive amount of hair
and/or debris, remove the rotating cleaning
brush for proper cleaning.
1. Unplug the vacuum and turn face down on a flat
surface.
2. Remove all three screws from the bottom of the base.
(See Figure 16)
Figure 16
3. Grip both the top cover and base while turning unit
back over. Lift off top cover.
4. Check drive belt. If broken or damaged, remove
rotating cleaning brush and replace drive belt.
(See Figure 17)
Figure 17
PAGE 6 OF 24
MAINTENANCE CONTINUED
5. To remove the
6. Remove drive belt
7.
8. Ensure furniture protection guard is in proper place.
Drive Belt
9. Place top cover onto base. Press into place,
10. Reinstall previously removed screws beginning with
rotating cleaning
brush, pull the right
side of the brush
toward the front of
the base and lift
slowly. (See Figure 18)
from cleaning
brush and clean as
necessary.
Place existing or new drive belt over rotating
cleaning brush and motor shaft. Insert the end cap
pin on the left end of the rotating cleaning brush
into the slot on the base. Slide the end cap pin on
the right end of the rotating cleaning brush into the
slot in the base and lower until it clicks into place.
(See Figure 19)
(See Figure 19)
Figure 19
Slot
Furniture Protection Guard
ensuring furniture protection guard is on the outside.
the center screw.
Figure 18
Slot
1022 IH-10166