Publicidad
Idiomas disponibles
Idiomas disponibles
Unfoldinginstructions
1
Remove the ebike from the package.
3
First remove the four
screws of the handlebar
stem, install the handlebar
in the center position and
tighten the screws(5.1 Nm)
Adjust the angle of the handlebar
stem to the position perpendicular
to the frame , first lock the screws
of the stem cover, and then lock
the two screws pointed by the
arrows.
2
Take out the front wheel set and
align it with the clearance of the
front brake before installing it,
then install.
4
Seat post quick
release
Install the seat, adjust it to a suitable
height and fix it with quick release.
A rod is pierced on the center shaft of the
wheel. Tighten the nuts at both ends, and
then use a wrench to lock it in a clockwise
direction.
The left pedal is tightened
counterclockwise and the
right pedal is tightened
clockwise.
05
Check whether there is a gap on
both sides of the disc rotor after
locking.
5
6
The bicycle battery has been
assembled before leaving the
factory, and can be removed
and installed later.
Publicidad
