Product Use - FITFIU FITNESS MC-500 Manual De Usuario

ASSEMBLY
Step by step
05
M4x10
M8x65
Use 2 M8x90 screws to fit the U-bracket to the vertical bracket, adding the washers.
To fit the main frame to the U-bracket, use the M8x65 bolts (x2) with M8 washers and nuts for a tight fit.
To finish off, use the screws more
Plug the machine into the mains, turn the power switch.
WARNING! After the assembly of this treadmill you may notice the two joining lines at the 2 ends of the
running surface, which guarantees its stability. It is made by a thorough heat-sealing process, which is the
most durable way to join the belt itself and ensure the product's lifespan.
Your MC-500 is now ready to use!
M8x20
M8x90

PRODUCT USE

Magnetic emergency stop system
The product is equipped with a "magnetic emergency stop system". This safety strap must be attached
to the console for it to work. It is designed to attach to clothing so that if you walk off or fall off the
treadmill, it will stop automatically, helping to prevent injury.
Before starting a workout, make sure the safety strap is properly attached to the console and that the
clip is securely attached to your clothing.
WARNING! If the device is switched on, but the safety strap is not connected, "- - -" appears on the
display and the device cannot be started.
Commissioning
The equipment has a computerised display that provides you with controls for the operation of the unit,
as well as information about the workout, duration, speed, distance travelled, etc. To use the equipment:
1. Plug the equipment into a mains socket.
2. Turn the power switch, located on the front of the unit, to the "ON" ("I") position.
3. Fix the safety strap to the console.
Your tape is ready!
BEWARE! Always stand on the side rails before starting the machine. Never stand on the belt and then
start the machine.
20
EN - MC-500