Cleaning Your Bike; Worn Parts - Lapierre sit and go! Manual De Utilización

IV—Maintenance

2 Cleaning your bike

After your ride, wash your bike with soapy water (liquid dish
soap is recommended for its ability to remove grease without
damaging the bike). Avoid using high-pressure washers if
possible. If you have to use one, avoid directing the stream
directly at the joints and bearings (for full-suspension models).
Dry your bike with a soft cloth in order to avoid rust and
corrosion. While carefully drying your entire bike, you will also be
able to inspect all the different parts and detect any potential
problems.
Before storing your bike in a clean and dry place, lubricate the
drivetrain parts with an appropriate product. You can also take
this time to control the brakes, see if the wheels are deformed,
and check for any play.
All manuals and user guides at all-guides.com

3 Worn parts

Always keep an eye on component parts that receive a lot of wear
and tear (especially the brakes) in order to avoid any risks. If you
have any doubts, you can check the manual from the component
manufacturer or check with your Lapierre
better to prevent than to heal, so never wait until the last minute!
List of consumable parts :
— Braking components (pads, rims),
— Tires, inner tubes, rim strips,
— Cables and casing,
— Transmission parts (chain, chainwheels, cassette,
bottom bracket),
— Shock struts and bushings.
If you have a problem with your bike, take it to your
authorized Lapierre dealer (with a proof of purchase).
™
The dealer will perform an initial diagnosis, and then
only he can send the bike back to our factory for a
warranty claim.
Lapierre 's warranty department has final say in all
™
warranty claims.
53
authorized dealer. It's
™
GB