Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.c - Fan speed
Press the "Speed" key (D1) to be able to select the fan speed:
Once fan speed is selected, the respective Led (L8) remains on.
If "LAUNDRY" mode is active, fan speed cannot be changed.
3.2.d - Timer function
Press the "Timer" (D1) key to set the delay time for "ON" (start) or "OFF" (switch off) modes.
In "ON" mode, press the "Timer" (D1); key once or more; the display shows the delay time for the appli-
ance switch off in hours (0 -> 1 -> 2 -> .... -> 23 -> 24 -> 0 -> 1 -> ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value
after which the appliance switches off (OFF); the (L1) led switches on in green.
In "OFF" mode, press the "Timer" (D1); key once or more; the display shows the delay time for the ap-
pliance start in hours (0 -> 1 -> 2 -> .... -> 23 -> 24 -> 0 -> 1 -> ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value
after which the appliance starts (ON); the (L1) led switches on in green.
To cancel the Timer function programming, press the "Timer" (D1) key once or more until selecting "0"
or press the "ON/OFF" (D6) key.
3.2.e - Activation of the display
Press the "Setting level of humidity" (D4) and "Led" (D3) keys simultaneously, the detected room
temperature appears on the displays.
The display (4b) shows the level of humidity with a series of colours:
Percentage of humidity >70%
Percentage of humidity 50-70% Green colour
Percentage of humidity < 50%
After approximately 20 seconds without pressing any key, the displays automatically reduce their brightness.
Press the "Led" key (D3), the displays and the active Led switch off, the machine continues to work.
3.2.f - Humidity level setting
Press the "Setting level of humidity" key (D4) to select the desired level of humidity in the room:
"CO" (Continuous cycle) ---> 30% ---> 35% ---> ... ---> 85% ---> 90% ---> "CO" (Continuous cycle) ---> ..
The settable value must be included between 30% and 90 % with 5% intervals.
After a certain period of operation, when the percentage of humidity in the room is lower than the set
value, the compressor stops temporarily.
After a certain period of operation, when the percentage of humidity in the room is lower than the set
value, the compressor stops temporarily.
Periodically, when the appliance is working (ON mode), dehumidification can be temporarily interrupted
in order to defrost the heat exchanger.
Upon switching on, the appliance starts in "Dehumidification" mode.
3.2.g - Child Lock function (Children safety)
Led"
Press the key "
(L5) switches on. In this condition, all buttons are locked.
Led"
Press the "
key (D3) again for approximately 5 seconds to deactivate the function.
High.
-- > Med.
Red colour
Blue colour
(D3) for approximately 5 seconds to activate the "children safety" function; the LED
-- > Min.
-- > High.
-- > ...
EN - 13
AQUARIA S1 20/24 P
Publicidad
