Features; Stand Assembly & Adjustment - Vornado 533DC Manual Del Propietário

FEATURES

Save energy by maximizing the performance of heating and cooling systems. When you use a Vornado Air Circulator, you will not have to
set your summertime thermostat as low or your wintertime thermostat as high.
DIRECTABLE
AIRFLOW
Direct the
airflow where
you want it.
SILICONE FEET
Non-marking feet
added for stability.
6
English
STAND ASSEMBLY & ADJUSTMENT
(MODEL 683DC)
STAND ASSEMBLY
1. Place the circulator head face down on
2. The upper pole and lower pole are
FINGER FRIENDLY DESIGN
Resists curious fingers.
3. Loosen the Adjustment Collar (F) by
REMOVABLE GRILLE
For easy cleaning.
4. Insert power cord (A) into the top of
AIR INLETS
Signature inlets and powerful
5. Push the circulator head into the pole.
motor to move more air.
6. Assemble Legs onto the base of Pole
VARIABLE SPEEDS
Speed setting for every
comfort level.
No tools required.
the ground on a soft surface.
pre-assembled with the Fastening Nut
(D) secured on the underside of the
base. Rotate Fastening Nut counter-
clockwise to remove and set aside.
NOTE: Poles must be
extended to fit on
circulator head.
gently rotating it counter-clockwise.
Extend the poles by 3-4 inches and
retighten collar.
A
Loosen
Pole and pull through the bottom.
NOTE: Do not
overtighten
Adjustment
Collar as height
Push until the Lock Release Button (B)
adjustment
snaps through the Hole (C).
could become
difficult.
by pushing each Leg onto the grooves
(E). Replace Fastening Nut (D) by
rotating clockwise to secure all the
Legs in place.
HEIGHT ADJUSTMENT
(32 - 38 INCHES)
1. Support the Circulator Head (G) with one hand.
Use your other hand to loosen the Adjustment
Collar (F) by gently rotating it counter-clockwise.
B
2. Slowly raise or lower the Pole to the desired
height and secure into position by rotating the
Adjustment Collar clockwise until tight.
Note: Before adjusting
C
the height or rotating
the head, check that
the power cord is not
E tangled and able to
move freely.
F
After adjusting height,
ensure that the
Adjustment Collar is
fully tightened and
engaged to ensure
Circulator Head does
not rotate and bind
power cord.
D
G
F
7
English