Publicidad
Idiomas disponibles
Idiomas disponibles
the full water level, the automatic water absorption stop device will not continue to be used.
At the end of the product use, please remove the handle, vacuum hose and dust tank and let the
main engine run for 5-10 minutes to dry the inside of the main device:
14) Press down on the handle buckle and pull out the vacuum hose connector
MAINTENANCE
During the maintenance, please be sure to turn off the device, and pull out the power plug.
Do not water the machine, which may cause electric shock, injury or failure.
Do not use detergent, thinner, volatile oil, bleach, etc.
Do not use chemical rags.
Main body
Use a soft cloth sucked in warm water (below 40 degrees) and wring dry, wipe dirt.
When the dirt is difficult to clean, please use a small amount of kitchen detergent to wipe the dirt,
in order not to let the detergent residue, and then dry the water stains with a wring cloth.
Handle, dust bin, vacuum hose
Please remove it from the main machine after each use and dry it after washing.
Clean handle with water after removing transparent cover of suction inlet.
If the nozzle is blocked, please remove the blockage after cleaning.
Control there isn't any damage on the vacuum hose.
Publicidad
