Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
PANERAI RADIOMIR 8 DAYS GMT
ORO ROSSO
0
1
2
W
INDING THE WATCH
1. Unscrew the winding crown (A) without pulling it out (position 0) and turn
it clockwise until the power reserve indicator (G) on the dial reaches the
fully-wound position indicated by the symbol
power reserve reaches the fully-wound position, the minimum power
reserve of the movement is 8 days. After this period has elapsed, the
indicator is positioned on the 'empty' symbol
watch has a minimum remaining power reserve that permits it to continue
working. However, to ensure an ideal movement rate, it is recommended to
wind the watch before the indicator goes beyond the 'empty' symbol
described above.
2. Screw the winding crown (A) down again.
B
C
D
A
E
F
G
. When the
but the
24
S
ETTING THE TIME
1. Unscrew the winding crown (A) and pull it out to the second click (position
2).
2. Ensure that the local time hour hand (B) is superimposed on the second
time zone hand (E). If this is not the case, return the winding crown (A) to
the first click (position 1). In this position the local time hour hand (B)
moves forwards or backwards in steps of one hour. Make the local time
hour hand (B) coincide with that of the second time zone (E). Then return
the winding crown (A) to the second click (position 2) to set the correct
time.
3. Pay attention that the hand (F) in the small seconds dial (D) indicates if the
local time is antemeridian or postmeridian. If this is not the case move the
local time hour hand (B) until the hand (F) will be positioned in the correct
side (AM or PM) of the small seconds dial (D). If, for example, it is 3 o'clock
in the afternoon, check that the hand (F) is in the left part (PM) of it. Then
set the correct time.
4. Push back the winding crown (A) to the initial position (0) and screw it down
again.
For a rapid change of the time, pull out the winding crown (A) to the first click
(position 1). In this position the hour hand (B) moves forwards or backwards
in steps of one hour without moving the minutes hand (C).
T
HE SECONDS RESET DEVICE
The small continuous seconds dial (D) is located at 9 o'clock. When the
winding crown (A) is unscrewed and pulled out to the second click (position
2) the small seconds hand immediately returns to zero. The seconds reset
device provides an extremely precise way of synchronising the watch with the
time source used as a reference.
Note: At the moment that the seconds reset device comes into operation, the
seconds hand is zeroed and the balance is stopped. If the crown should
25
Publicidad
