Assembly, Installation, Start-Up - Oase BIOsys Skimmer Instrucciones De Uso

Assembly, Installation, Start-up

Before you begin installation, please decide exactly where you want to install
the skimmer. It should definitely be located in the prevailing wind direction. The
skimmer must later be installed in such a way that the neutral water level lies
in the center of the opening, allowing for a 5 cm fluctuation in the water level
both up and down.
If possible, use 1½" pressure hoses and suitable hose clips for the hose
connections (skimmer to filter).
Smaller diameters are possible, though they result in reduced pump capacity.
Assembly
1. Connect the pressure unit (13) with the gasket (14) and the nut (15) (Fig1.).
2. Cut the stepped hose adapter (17) to the required hose diameter (Fig.) and
3. Reduce the water level as far as necessary and excavate the requisite
4. Attach the hose to the container using the gasket (16). Make sure that the
5. Insert the container at the appropriate height (Fig.2) and lay the hose,
6. Before connecting the liner to the container via a flange, begin by attaching
7. Screw together the outer frame (4), frame seal (5), pond liner, container
8. Use a sharp knife to cut the liner out of the inlet opening and connect the
9. Remove the filter casing of the Aquamax pump and connect the pump
10. Lay the pump's supply cable along the rear container wall, ensuring there
11. Lift the float flap (7) until it slots into position and place the strainer (2) in
12. Connect the skimmer hose to a filter if required and fill your pond to the
13. Switch on the pump. The float flap (7) should now move to just beneath
14. Check that all hose connections are watertight and fill in the rest of the
15. Finally place the decorative cover (3) on the skimmer container (1)
BiosysSkimmer.p65
GB Operating instructions Gebrauchsanweisung
procedure:
attach the stepped hose adapter (17) to the hose using the union nut (18).
If necessary, briefly immerse the end of the hose in boiling water to make it
easier to fit. Make the connection secure with a hose clip.
amount of soil.
connecting parts are tight.
making sure that there are no twists in it and that it cannot be stepped on.
the float flap (7) and the two fans (8) to the inner frame (6) (Fig3.).
(1) and inner frame (6) (Fig. 4).
buoyancy device (9) to the back of the float flap (7).
fitting (12) to the pressure nozzle of the pump as shown in Fig.
are no twists, and fix the cable using the cable duct strip (10).(Fig. 1)
the container. Please ensure that the handles of the collector are resting in
their slots on the container wall and then release the float flap again.
normal water level (the center of the skimmer opening). At the same time
fill in the ground around the container with soil. However do not cover the
hose connection at the back for the time being in order to be able to carry
out a check for watertightness.
the water surface.
ground around the container (1) with soil.
7
GB
12.03.2003, 09:11
7