Powerfix Profi PLPRS A1 Instrucciones De Uso página 47

Melting and filling (Figs. C + D)
♦
♦
♦
GB
NOTICE
MT
►
Filling (Fig. E)
♦
Smoothing (Fig. F)
♦
♦
Fine matching (Fig. G)
♦
♦
Degreasing (Fig. H)
♦
Cleaning the planer grooves (Fig. I)
♦
44
Place the On/Off switch
"ON" to switch the appliance on.
Press and hold the activation button
heat up the wax melter tip
Now melt small portions of the hard wax and
place them into the damaged area, until it is
slightly overfilled. Start with the light colour
tones and progress step by step to the dark
colour tones.
At pressure points it is often sufficient if you
use only the transparent hard wax (K).
For vertical surfaces it is recommended to mix
the colour tone beforehand, collect it on the
spatula and then fill the damaged area.
When working on curved areas the scraper
with curvature
wax into the damaged area.
Allow the hard wax to cool for a few seconds
(about 10 seconds).
After cooling, smooth any protrusion with the
planing grooves of the scraper
light pressure to smooth the protrusion.
For fine matching, now imitate the grain struc-
ture with a darker colour tone.
Subsequently, again smooth any protrusion
with the planing grooves of the scraper
To finish, remove the last hard wax residues
with the sanding sponge
gloss level of the surface will also be simulta-
neously matched. Job done!
Place the cleaning scraper
wax melter tip
dues from the plane grooves.
at the position
.
should be used to fill hard
. Thereby the
on the cooled
and scrape the wax resi-
to
. Use only
.
PLPRS A1