One for All UCR-7555 Manual Del Usuario página 10

Important notes:
- During steps 2 - 7 (page 9), you have approximately 10 seconds to conduct each
step. If there is a gap of more than 10 seconds between two steps, you will have
to start again from step number 2.
- If you learn a function on a key, the original ONE FOR ALL feature automatically
becomes shifted. You can press MAGIC then the key to access it (this excludes the
Channel and Volume keys).
- The Learning feature is mode specific. Therefore you can place one learned fea-
ture per mode on the same key.
- If a Shifted Learned function is placed on the Channel and Volume keys then
Colour/Brightness will be sacrificed.
- The ONE FOR ALL 5 can learn approximately 25 – 40 functions.
- You can replace a learned function by placing another learned function on top.
- Learning should not be done in direct sunlight or under incandescent lights.
- Make sure you are using new batteries before following the instructions above.
- Upon changing the batteries, your learned functions will be retained.
• Shifted Learning
You can also learn a function on a key of the ONE FOR ALL without
sacrificing the original ONE FOR ALL function. A Shifted Learning function can
also be put on any key EXCEPT for the following: Device keys, MAGIC key,
Number keys. To install a Shifted Learning function, simply follow steps 1-8 on
the previous page. During step 5, press MAGIC once before you press the key
where you are placing the learned function.
To access the shifted function, press MAGIC and then the key you have
learned on.
10
The Learning Feature
WWW.ONEFORALL.COM