Manuales relacionados para Truper ESMA-9N4
Resumen de contenidos para Truper ESMA-9N4
- Página 1 Manual Angle Grinder 3.3 Hp 9” Power Disc Applies for: Code Model 12483 ESMA-9N4 ESMA-9N4 Read the user’s manual thoroughly CAUTION before operating this tool.
-
Página 2: Tabla De Contenido
Contents CAUTION Technical data Power requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety standards for angle grinders of fatal injuries please read and understand this Manual before Parts using the tool. -
Página 3: Technical Data
Technical Data ESMA-9N4 Code 12483 Description Angle Grinder Discs 9” Voltage 127 V Frequency 60 Hz Current 18.9 A Power 3.3 Hp Speed Screwed thread size 6 700 RPM 5/8-11-UNC-1A Duty Cycle 50 minutes’ work per 20 minutes’ idle. Maximum 6 hours per day Conductors 12 AWG x 2C with 221 °F insulating temperature... -
Página 4: General Power Tool Safety Warnings
General power tool safety warnings WARNING! Read carefully all safety warnings and instruction listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. - Página 5 Safety warnings for angle grinders This power tool is intended to function as a cutting tool. Read all safety warnings, instructions and specifications provided.Failure to follow the instructions outlined below may result in electric shock, fire and/or serious injury: While operating the grinder Select the right disc CAUTION •...
-
Página 6: Safety Warnings For Angle Grinders
Safety warnings for angle grinders DANGER KICKBACK (Sharp Recoil) Do not use accessories that are not specifically designed and recommended by the manufacturer. The fact that the Kickback (sharp recoil) is a sudden reaction when a rotating wheel, backrest, brush, or other accessory gets accessory may be installed on the power tool does not ensure safe operation. -
Página 7: Parts
Parts Protective Spindle Lock Nut Guard Lock Wrench (Included) Handle Guard Bracket Spindle Lock Abrasive Disc model ABT-223 (9”) included Vibration Absorbing Auxiliary Handle Guard Bracket Outer Disc Flange Inner Power Flange Supply Cord Auxiliary Handle Assembling Orifice Guard Power Bracket Cord Protector Protective... -
Página 8: Auxiliary Handle Assembly
Preparation Auxiliary Handle Assembly CAUTION Before performing any operation, always make sure that the auxiliary handle is firmly installed. Set the auxiliary handle in one of the three positions according to the operator's preference and the job to perform. Start Up The Angle Grinder is a manual power tool. -
Página 9: Maintenance
Maintenance • Always disconnect the tool before cleaning. • Never use water or other liquids. Use only a brush. • To prevent overheating the motor, clean the ventilation slots regularly. • Double-check all the tool components are securely fastened. • The housing should not be cracked or damaged. •... -
Página 10: Notes
Notes • ENGLISH... -
Página 11: Authorized Service Centers
Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. -
Página 12: Warranty Policy
® require any proof of purchase to make the warranty effective. Phone number 800-018-7873. Made in China. Imported by Truper, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.