Uline H-10162 Manual De Instrucciones página 4

ADJUSTING MONITOR AND CABLE MANAGEMENT
1. If the monitor needs to be adjusted, use the 6 x 6 mm Allen wrench to loosen and tighten the tension screws.
(See Figure 10)
2. Attach plastic covers to top and bottom of wall plate. (See Figure 10)
3. Attach cable management clips to the top and bottom of the wall plate and support bars. Cables can be
managed by running them through the clips. (See Figure 10)
Figure 10
Plastic Cover
Plastic Cover
REMOVING THE MONITOR
With second person, pull down on the strings attached
to the brackets. This will unlock the brackets from the
wall plate, and the monitor can be removed.
(See Figure 11)
PAGE 4 OF 14
INSTALLATION CONTINUED
Cable Management
Clip A
1-800-295-5510
Cable Management
Clip B
uline.com
6 x 6 mm
Allen Wrench
Tension
Screw
+ 45º
–
+ 180º
–
90º
+
3º
+
–
–
-2º–10º
Figure 11 Figure 11
1122 IH-10162