Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING AND CONTENTS
:
IMPORTANT
Due to modern mass production techniques, it is unlikely the product
is faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Scissors w/ 55° Cutting Head 1
75°
Cutting Head
Charging Stand
OPErATION
WArNING:
important safety warning and instructions before using this tool.
WArNING:
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY
PACK (FIG 2)
•
To install the battery pack, insert the battery pack (6) from the bottom of
the tool all the way into the battery port (11) until it locks in place with a
click, as shown in fIG 2.
•
To remove the battery pack, slide the battery release (5) to the left to
release the battery pack, then pull the battery pack out.
CHARGING THE BATTERY (FIG 3)
NOTE:
Always Check that the power supply corresponds to the voltage on the ratings plate.
•
Connect the charging adaptor (7) and the charging stand (8).
•
Plug the adaptor into a 120 volt AC power source. The GREEN light on the charging stand will illuminate,
indicating the charger is powered.
•
Insert the battery (6) all the way into the charging stand until it locks in place with a click, as shown in
fIG 3. The RED light on the stand indicates that the battery is charging.
•
The light will turn GREEN after charging is complete.
•
To remove the battery from the stand, depress the locking tab on the stand to release the battery pack.
See fIG 3.
•
The battery pack may become warm while charging. This is normal.
•
If the battery is hot after continuous use in the tool, allow it to cool down to room temperature before
charging. This will extend the life of your battery.
NOTE:
It takes approximately 3-5 hours to fully charge a completely discharged battery.
:
QTY
Description
Battery Pack (GLAB0820B)
1
Charging Adaptor
1
Operator's Manual
To reduce the risk of serious personal injuries, read and follow all
Always be sure that the tool is switched off before insertion or
FIG 3
QTY
1
1
1
11
6
7
8
Locking Tab
5
6
FIG 2
7
Publicidad
