Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Installation procedure
a
Cooktop
b
Countertop
c
Wooden block
Required for installation in countertops that
are between 2" (50 mm) and 2¾" (70 mm)
thick.
d
Long clamping screw
Required for installation with wooden block.
Available for purchase from Customer Ser-
vice (order no. 10011930).
Note: Do not use silicone to glue the cooktop to the coun-
tertop surface.
4.4 Flush mounting
Complete the normal installation of the appliance mak-
1.
ing sure that it is surrounded by a uniform slot. The
cooktop surface should be slightly below the countertop
surface. For tiled countertops, raise the supporting sur-
faces with water- and temperature-resistant strips, if
necessary.
Check the operation and position of the appliance.
2.
Fill the gap between the countertop and the cooktop
3.
with conventional silicone sealant in the desired color.
Unsuitable silicone sealant used on natural stone sur-
faces can lead to discolorations that cannot be re-
moved. Follow the manufacturer's instructions for the
silicone sealant.
12
Smooth the silicone sealant with a wet and soapy
4.
scraper or finger before it forms a layer.
Allow the silicone sealant to dry before using the appli-
5.
ance.
4.5 Connection overview
Refer to this illustration for the location of the gas and
electric connection of the appliance.
Note: Your appliance is equipped for use with natural gas
on delivery. If you want to use your appliance with LP gas
refer to the section on LP gas conversion before continu-
ing with the installation.
a Cooktop rough-in box
b Arrow on pressure regulator, shows the direction of
gas flow
c Pressure regulator
d ½" female pipe threads
e Metal flex gas line
f Power cord (40"/1 m)
g 120 V receptacle
h Gas cut-off valve
i
Gas supply line connection fitting
j
Floor
Publicidad
