Publicidad
Idiomas disponibles
Idiomas disponibles
5、 Insert the frothing device into the milk about two centimetre, froth milk in the way moving
vessel round from up to down.
7. When the required purpose is reached, you can turn the steam control knob to "o"
position.
Note: Clean steam outlet with wet sponge immediately after steam stops generating, but
care not to hurt!
7、
Pour the frothed milk into the espresso prepared, now the cappuccino is ready.
Sweeten to taste and if desired, sprinkle the froth with a little cocoa powder.
8、
Press the
Power
: After finish the "Steam" function, press the coffee switch, if the coffee indicator and
WARNING
steam indicator blink fast, it means that the temperature of the appliance is too high and the
appliance needs to be turned off and have a rest for more than 5 minutes, or you can activate
the "Hot water" function to cool down the appliance. And the water pump will stop pumping
water automatically if the temperature is normal. And the coffee will be burnt and there will be
overflow at the funnel if the appliance brew coffee directly without being cooled down.
AUTOMATIC POWER OFF FUNCTION
If there is no any operation within 25 minutes, the unit will power off automatically.
FACTORY RESET
After finish preheating, hold and press the power switch, coffee switch and steam switch for 3
seconds at the same time, and their corresponding indicators will blink for 3 times, then the
factory reset is finished.
CLEANING AND MAINTENANCE:
1、
Cut off power source and let the coffee maker cool down completely before cleaning.
2、
Clean housing of coffee maker with moisture-proof sponge often and clean water tank,
drip tray and removable shelf regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for
cleaning.
3、
Detach the metal funnel by turning it clockwise, get rid of coffee residue inside, then
you can clean it with cleanser, but at last you must rinse with clear water.
4、
Clean all the attachments in the water and dry thoroughly.
CLEANING MINERAL DEPOSITS
A descaling prompt will occur automatically after working for 500 cycles cumulatively, at that
time all
,
the indicators will quickly blink for 5 times at the same time after preheating is finished.
And the appliance will become normal again after the descaling is finished.
switch to cut the power source off. All indicators will be extinguished.
Publicidad
