Publicidad
Idiomas disponibles
Idiomas disponibles
Symbols used:
Prohibited
Important
Assembly on the wall:
1. Install the wall mounts:
1. Draw marks on the wall to ensure the holes are performed in the correct place.
Note that they must be aligned vertical and horizontally. The distance between
both holes (L) is the length of the canopy less 110 mm.
2. With the assistance of a drill, drill the holes for the wall mounts . The diameter
of the holes must be 12 mm and as deep as the expansion screws.
3. Insert the expansion screws in the holes with the help of a hammer and remove
the nuts and washer.
4. Secure the expansion screws, place the wall mounts and put the nuts and
washers back on the bolts before hammering them into the wall.
The expansion screws must be hammered completely into the wall.
If you are going to use 3 wall mounts, ensure that the middle one has been
perfectly centred.
The bolts must project out of the wall so that the mounts may be installed on
them .
EN
Publicidad
