Publicidad
HDMI™ Switch 3 to 1
EN
Commutateur HDMI™ Manuel 3 sur 1
FR
Do not operate a device if it is not in working order. In such
cases, it must be secured against unintentional further use.
• Use product, product parts and accessories only in per-
fect condition.
• Avoid stresses such as heat and cold, moisture and di-
rect sunlight, microwaves, vibrations and mechanical
pressure.
• In case of questions, defects, mechanical damage, trou-
ble and other problems, non-recoverable by the docu-
mentation, contact your dealer or producer.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against
accidental use.
Heat storage
• Do not cover the product.
• Keep enough space around all devices for a good vent-
lation and free motion and to avoid damages.
2 Description and function
2.1 Product
The product is an HDMI™ switcher that allows up to 3x
HDMI™ source devices to be connected to 1x HDMI™ out-
put device simultaneously. The input signal can be selected
by pressing the switch button.
2.2 Scope of delivery
58487: HDMI™ Switch 3 to 1 (4K @ 30 Hz), User Manual
58488: HDMI™ Switch 3 to 1 (4K @ 60 Hz), User Manual
2.3 Operating Elements
See Fig. 1.
1 LED status indicators
2 Switch button
3 HDMI™ plug (output)
3 Intended use
This product is intended exclusively for private
use and its intended purpose. This product is not
intended for commercial use. We do not permit
using the device in other ways like described in chapter
„Description and Function" or in the „Safety Instructions".
Use the product only in dry interior rooms. Not attending to
these regulations and safety instructions might cause fatal
accidents, injuries, and damages to persons and property.
4 Preparation
1. Check the scope of delivery for completeness and in-
tegrity.
2. Compare the specifications of all used devices and en-
sure compatibility.
5 Connection and operation
See Fig. 2.
1. Connect up to three source devices to the HDMI™ so-
ckets (input) (4) of the switcher.
2. Connect an output device to the HDMI™ plug (out-
put) (3) of the switcher.
Connection cables are not included in the scope of delive-
ry. Make sure that the source and output devices as well
as the connection cables support the resolutions and stan-
dards of the product!
If several source devices are connected, the switcher au-
tomatically switches to the active device or the device that
was connected last.
3. Press the switch button (2) to switch between the in-
put signals.
Press the switch button (2) to switch between the input si-
gnals.
The LED status indicators (1) light up when the respective
HDMI™ socket is active.
Item 58488 has a Micro USB socket (5) that allows you to
connect an additional power source (5.0 V
improve the performance of the switcher. The use of an
REV2022-10-28
Subject to change without notice. |
V1.0aw
Sous réserve de modifications.
4 HDMI™ socket (input)
5 Micro USB socket
, 1.0 A) to
additional power source is not essential as the switcher is
already powered by the HDMI™ connections.
A charging adapter is not included in the scope of delivery.
6 Maintenance, Care, Storage and
Transportation
The product is maintenance-free.
NOTICE!
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry
and dust-protected ambience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.
7 Disposal instructions
According to the European WEEE directive, electri-
cal and electronic equipment must not be disposed
with consumers waste. Its components must be re-
cycled or disposed apart from each other. Otherwi-
se contaminative and hazardous substances can damage
the health and pollute the environment.
As a consumer, you are committed by law to dispose elect-
rical and electronic devices to the producer, the dealer, or
public collecting points at the end of the devices lifetime for
free. Particulars are regulated in national right. The symbol
on the product, in the user manual, or at the packaging all-
udes to these terms. With this kind of waste separation, ap-
plication, and waste disposal of used devices you achieve
an important share to environmental protection.
WEEE No: 82898622
1 Consignes de sécurité
Le mode d'emploi fait partie intégrante du produit et com-
prend d'importantes informations pour une bonne installati-
on et une bonne utilisation.
• Lisez le mode d'emploi attentivement et complètement
avant de l'utiliser.
Le mode d'emploi doit être disponible à des incertitudes et
transfert du produit.
• Conservez soigneusement ce mode d'emploi.
• Ne pas ouvrir le boîtier.
• Ne modifiez pas le produit et les accessoires.
• Pas court-circuiter des connexions et circuits.
Un appareil défectueux ne doit pas être mis en service. Il
doit au contraire être protégé contre toute utilisation invo-
lontaire.
• Utilisez le produit, pièces et accessoires des produits
uniquement en parfait état.
• Éviter des conditions extrêmes, telles que la chaleur ex-
trême et froid, l'humidité et de la lumière directe du so-
leil, ainsi que microondes, des vibrations et de la pres-
sion mécanique.
• En cas de questions, les défauts, les dommages méca-
niques, des ingérences et d'autres problèmes, non ré-
cupérables par la documentation, contactez votre re-
vendeur ou le producteur.
Non destiné à des enfants. Le produit n'est pas un jouet !
• Sécuriser l'emballage, petites pièces et l'isolation contre
l'utilisation accidentelle.
Accumulateur de chaleur
• Ne couvrez pas le produit.
• Laissez toujours suffisamment d'espace qu'autour du
système afin de garantir une ventilation appropriée et
de l'espace entre les appareils pour ne pas risquer de
les dommager.
- 3 -
Pillmannstraße 12 | 38112 Braunschweig | Germany
58487, 58488
Material damage
Goobay® by Wentronic GmbH
Publicidad
