Descargar Imprimir esta página

VORAGO 302 V2 Guía Rápida página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUST THROTTLE AND BRAKES
If a brake is too tight: use an M5 hex key and adjust the
screws counterclockwise of the brake disc tensioner pulley,
slightly shorten the length of the rear brake cable, and
then tighten one tensioner pulley. If you think the brake is
too free, loosen one idler pulley, pull on one brake cable to
slightly increase the length of its tail. Tighten one idler.
Steering rack: Using an M5 hex key, tighten two screws
near the folding mechanism.
If a rear wheel goes flat, connect a connecting tube to
the wheel nipple to pump it up. First, remove the cap
from the pin, then tighten it and start pumping.
STARTING THE SCOOTER
To turn on/o , press the button 1 second.
To turn on/o the front and rear light, press the button
twice.
To select the speed, briefly press the button. The di erent
gears with their corresponding speeds are listed in the
following table:
1.-
0-6km/h
2.-
7-15km/h
3.-
15-25km/h
Battery: There are a total of 4 LEDs, which indicate the
battery level. If all 4 LEDs are on, the battery level is 70%
to 100%; if the 3rd LED lights up, the battery level is 50%
to 69%; if 2nd LED lights up, battery level is 10% to 30%. If
1st LED, the battery level is less than 10%, please charge
the scooter
00
Speed
Gear indicator
Battery indicator
Switch

Publicidad

loading