Publicidad
Idiomas disponibles
Idiomas disponibles
Initial Operation
Open the battery cover and insert the batteries with the correct polarity.
Then remove the batteries for about 10 seconds and insert the batteries again.
This operation is necessary only at the very first start-up, to enable the search for radio controlled
time
Radio Controlled Time:
The clock automatically starts scanning the DCF time signal (
The clock automatically scans the time signal at 3:00a.m. everyday to maintain accurate timing. For
failed reception, scanning stops (
5:00a.m, and 6:00a.m.
The clock manually scans the time signal by holding buttons "+"(B3) & "- "(B4). For failed reception,
scanning stops (
received.
Stop scanning by holding "+"(B3) & "-"(B4)buttons.
flashes indicate now is receiving the DCF signal
turns on indicate signal received successfully
"DST" show on the LCD if it is in Daylight Saving Time Mode.
Display Modes
Press "MODE" button (B2) to change the display content:
Radio Controlled Time
Manual Time Setting:
When the time is displayed on LCD, hold "MODE" button for 2 seconds to enter time setting mode.
When the hour digit flashes press "+"(B3) or "-"(B4) to adjust the hour
Press "MODE" button (B2) to confirm the setting
Repeat this procedure for the other settings
The settings have the following order: hours, minutes, time zone (for UK time set -1), language for
weekday, year, month, day
The TIME SETTING mode will automatically exit in 8 sec without any adjustment.
on LCD disappear) and repeats again at 4:00a.m,
on LCD disappears) and repeats again in the next 4 hours (4 times) until
Time + week
Alarm Time
EN2
flashes on the LCD)
Publicidad
