Before Using The Appliance; Use Instructions - Ga.Ma SALON EXCLUSIVE PRO 9 XPERT Manual De Instrucciones

Idiomas disponibles

BEFORE USING THE APPLIANCE:

Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO

LUBRICATE THE BLADE"

Adjust motor power. After oiling the appliance, its operation could be inefficient; therefore it is necessary to

turn it on and follow the instructions given below to achieve optimal operation:

2. Turn the screw clockwise until hearing the loud noise emitted by the motor when it reaches the maximum

speed; immediately after this, turn it anticlockwise until the motor noise decreases. Stop turning the

screw only when the blade is horizontally aligned with the head and not beyond.

3. At this point the motor power has been adjusted and the hair clipper is ready for use.

• Insert the desired attachment. This operation should always be done with the hair clipper turned off.

• Turn on the hair clipper by pressing the (O/I) button.

• Turn off the hair clipper by pressing the (O/I) button.

INSERTION OF COMBS:

The supplied combs have two snap on seats. One near the teeth of each comb (Fig. 2) and the other near the

base of each comb (Fig. 3). To insert the combs in the hair clipper, set the snap on base near the teeth of the

comb on the hair clipper blade and then push the base of the comb against the base of the blade head until

you hear a slight click: insertion will be now be completed. Remove the combs using the tab located on the

base of the comb, exerting an outward force.

1. There is a black screw (Fig. 1) on the right side of the body of the

appliance that can be used to change the power of your hair clipper's

motor. This screw has been previously calibrated in our production line;

however, depending on the voltage where the appliance is used, you

may need to adjust it again. For this operation, you will need a screwdriver

to be inserted in the screw cavity.

Tabla de Contenido