Worx Nitro WX352 Manual De Instrucciones página 12

K & K
PA WA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Drilling into metal
Impact drilling
into concrete
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in
12
which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
20V Cordless Impact Drill
Vibration emission value
a = 2.151m/s²
h,D
Uncertainty K = 1.5 m/s²
Vibration emission value
a = 10.712 m/s²
h,ID
Uncertainty K = 1.5 m/s²
Plan your work schedule to spread any high vibration
5.0 dB(A)
tool use across a number of days.
SUGGESTED BATTERIES AND
CHARGERS
Category
20V Battery
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
4.INTENDED USE
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood,
metal and plastic.
5.OPERATING
INSTRUCTIONS
NOTE:
instruction book carefully.
ASSEMBLY AND OPERATION
BEFORE OPERATION
Checking the battery charge
condition
NOTE: Fig. A1 only applies for
the battery pack with battery
indicator light.
Removing the battery pack
Charging the battery
Installing the battery pack
Model
WA3550
WA3550.1
WA3551
WA3551.1
WA3553
WA3760
WA3772
WA3880
Before using the tool, read the
ACTION
See Fig. A1
See Fig. A2
See Fig.A3
See Fig.A4
Capacity
1.5 Ah
1.5 Ah
2.0 Ah
2.0 Ah
4.0 Ah
0.4 A
2.0A
2.0 A
FIGURE
EN