Lionelo Liam Manual De Usuario página 11

A - to low (tight)
B - to hight (loose)
C - correct
5.7 Seat angle adjustment
The seat can be adjusted to three different positions.
5.7.1 In order to change the seat angle, put your hand under the seat, then
press and hold the lock. Moving the hand up or down choose a desirable seat
angle. In order to tilt the seat down you can use the other hand to push the
upper edge of the seat (fig. 11A).
5.7.2 The arrows on both sides of the base indicate the seat angle (fig. 11B).
5.7.3 Red arrows indicate position 1 and 2. These settings are
reserved for the I age group and can only be used when the seat is
installed in a forward-facing position (fig. 12A).
5.7.4 Position 3 indicated by blue arrow is reserved for children from
the 0+ age group. It is a reclining position, which requires the seat to be
installed in a rear-facing way (fig. 12B).
5.7.5 W h e n t h e s e a t p o s i t i o n i s n o t a l i g n e d w i t h a ny
of the arrow, it means that it has been adjusted improperly and can be
dangerous for the baby. In that case it is necessary to correct the seat
position immediately.
6. Installation and usage for the group 0+
The safety seat must be installed in a rear-facing position. The back
must be tilted to the position number 3 indicated by the blue arrow.
6.1. Installation of the safety seat in a car
6.1.1. Adjust the back of the safety seat so that it is in the position number
3 indicated by the blue arrow.
6.1.2. The safety seat should be installed in a car equipped with 3-point
seat belts.
6.1.3. First, pull the vehicle's seat belts as much as possible.
6.1.4. Run the lap belt and the shoulder belt through the safety seat (fig. 13).
‑ 11 ‑ EN