Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTION
- Connect the loudspeakers to the loudspeaker output required depending on its installation. Do not use
more than one type of output at a time.
- The loudspeakers must be connected in a series/parallel circuit so that the load impedance of the
loudspeakers is the same as the load impedance of the amplifier output and that the power supplied by
the amplifier does not exceed that withstood by the loudspeakers.
- Once the connections have been made acording to your needs, connect the devices to the power supply
and switch them on. After use, do not forget to switch off and disconnect the device from the power supply.
This amplifier has three operating modes that can be selected using the selector located on the rear part of
the device: parallel mode (PARALLEL), stereo mode (STEREO) or bridge mode (BRIDGE.
PARALLEL MODE
Place the selector in the PARALLEL position. In this mode, the outputs A and B will receive the amplified
signal from the CH A input. Connect the CH A input and the two loudspeaker outputs. The volume of the
output channels is adjusted separately.
- 3 -
EN
Publicidad
