RF Solutions FOBLOQ Serie Manual De Instrucciones página 9

FOBLOQF Remote Control
Data Outputs
Each output relay provides an isolated switch. Outputs 2 to 4 Connections are Common (COM)
and Normally Open (NO) which close together when activated. Output 1 has an additional
Normally Closed (NC) changeover contact.
The action of the relay outputs us set by Option link setting Jumper. A link is made / re-
moved by the small shorting link 'cap' placed over the pin header.
Option Link 1 Fitted = Momentary Operation
Option Link 1 Not Fitted = Latching Operation
Please Note:
The relay contacts in this unit are for functional use only and must not be used for isolation
purposes.
WARNING When used to switching mains voltage this
competent electrician.
Option Links
Learning a New Transmitter Keyfob
Briefly short the two 'learn' pins on the receiver PCB, the receiver relays will click continuously.
Press any transmitter button once, the receiver relays will stop.
Press the same transmitter button again, the receiver relays will 'buzz' briefly.
After a short time delay for reset, this transmitter will operate the Receiver.
Erasing Existing Transmitters
Short the two learn pins on the receiver for 10 seconds then remove the short.
The receiver relays will 'buzz' briefly after the 10 seconds to indicate the Tx encoder(s) have been
erased
NOTE: You can not erase individual Transmitters
NO COM NO COM NO COM
0V 12V
DS-FOBLOQFS-2
product must be installed by a
24V