Power Dynamics PDM-T Serie Manual De Instrucciones página 4

21. MAIN OUTPUTS
XLR and 6.3mm jack outputs, to connect an active speaker or amplifier.
22. DSP DISPLAY
Display showing the 380 DSP effects.
23. SELECT BUTTONS
Press up/down to select desired DSP effect.
24. MEMORY BUTTONS
Press to recall one of 4 saved DSP memory slots.
25. MP3 DISPLAY
Display showing, for example, song name, play time, etc.
26. USB PORT
USB entry port for MP3 input or computer connection.
27. MP3 CONTROL KNOB
Rotate to select previous or next track. Push to (re)start/pause play.
28. REC AND REPEAT/MODE BUTTONS
REC: Long press to initiate record function. Short press to finish recording and play the recorded audio. When playing the
recorded audio, short press to switch to USB mode. When playing USB, short press to switch to playing recorded audio.
REP/MODE: Short press to change modes (USB, BT, REC). Long press to change repeat modes (ALL, ONE).
29. MP3 EQ CONTROL
Two-band equalizer for the MP3 player.
30. +48V PHANTOM BUTTON/LED
When the button is pressed to turn on, the +48V LED light will illuminate, providing DC+48V phantom power to the XLR plug
on microphone mono input. Turn on this function when using a condenser microphone that is powered by phantom power.
31. POWER INDICATOR
Lights up when the power is on.
32. LEVEL INDICATOR
Shows the signal level from the main output. Adjust the faders or volume level controllers to lower the level if the indicator
lights up in red.
33. STEREO GRAPHIC EQUALIZER
7-band equalizer to adjust the sound signal sent to the main output jacks.
34. AUX1 & AUX2
Turn to adjust the volume level of AUX1 and AUX2 outputs.
35. RETURN CONTROL
Turn to adjust the return signal level.
36. CD/TAPE CONTROL
Turn to adjust the CD/TAPE output level.
37. PFL INDICATOR
After activating PFL function (by pressing the PFL button), this indicator lights up.
38. HEADPHONES CONTROL
Turn to adjust the signal level sent to the phones out jack.
39. FX FADER
Slide to control the effect input.
40. MP3 FADER
Slide to control the MP3 volume level.
41. G1/G2 FADER
Slide to control the G1/G2 group volume level.
42. MAIN MIX FADER
Slide to control the main (master) volume level.
43. G1/G2 TO MAIN
Press to redirect the G1/G2 signal to main channel output.
44. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord (top). For instructions on how to change the fuse (bottom), see "REPLACING
THE FUSE".
45. POWER SWITCH
Switch to turn the device on/off.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
BT STREAMING
Press the MODE button repeatedly to select BT mode. Now the mixer can be found by mobile device for the purpose of
streaming. When pairing is successful, a sound will be emitted.
4