Emerio MC-122646.1 Manual De Instrucciones página 5

MC-122646.1
GENERAL DESCRIPTION
BEFORE USE
1. Remove the appliance from the packaging.
2. Take care when handling sharp blades.
3. Clean the appliance as described in section "cleaning and maintenance".
USE
1. Attach the blades on to blade support in the jar and pour in the food to be chopped. Hard food must be cut
into small pieces (about 2cm). Otherwise, the motor may block.
2. Place the lid on top of the jar. Place the motor unit on the lid. Rotate the motor unit in clockwise direction
until it is locked with the jar by the two tabs (A & B) on the edge of the jar.
3. Plug the appliance in. Press the on/off button for processing.
Note: After put the food in the jar, if the blades cannot speed up in a few seconds, please unplug the unit and
take out part of food, then continue.
4. After use, unplug the appliance and wait unit the blade stops completely. Remove the motor unit, the
removable lid and the blades.
Always make sure the motor unit is in place; otherwise the unit will not function. After finish processing, the non-
slip mat can also be used as the cover of the jar.
Take note of the following table:
Foodstuff
Vegetables (cut into small pieces of 20x20x50mm)
Meat (cut into small pieces of 20x20x50mm)
1. Motor unit
2. Lid
3. Jar
4. Non-slip mat
5. Stainless steel blade
6. Blade support
7. On/off button
Filling quantity Processing time
≤200g 15 seconds
≤200g 30 seconds
- 4 -
EN