Publicidad
Idiomas disponibles
Idiomas disponibles
3. Steam ironing is only possible when the highest temperatures shown
on the temperature control are selected .Otherwise ,water may escape
through the soleplate.
4. Wait until the pilot light goes out, which indicates that the selected tem-
perature has been reached.
5. Turn the steam button to the required position.
6. When the ironing is finished and during breaks in ironing , place the iron
in its upright position.
7. Disconnect the iron from the power supply . Pour of any remaining water
and leave the iron to cool off.
Spray
Press spraying water button a couple of times to moisten the laundry if
necessary, before spraying make sure that there is enough water in water
tank.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the "max"position and wait until the
pilot light goes out
2. Wait for a few seconds for the steam to penetrate the fibre before pres-
sing again.
Note: For the best steam quality, do not use more than three successi-
ve bursts each time. Several pumping actions are needed to start this
function.
Anti drip
The iron has an anti-drip function: this prevents water escaping from the
soleplate when the iron is too cold.
Auto shut-off
If the iron is motionless,it will switch off after about 30 seconds with the
soleplate down,or about 8 minutes if it's upright.
INGLÉS
17
Publicidad
