Publicidad
Idiomas disponibles
Idiomas disponibles
5. Installation / 6. Maintenance and cleaning
5.6 Changing the COM port of the adapter
1. With the adapter plugged in, access the device manager.
⇒
Start \ Settings \ System control \ System \ Hardware
2. Open the sub-item Connections (COM and LPT).
If the installation was successful, the entry "CP210x USB to UART Bridge Controller
(COM x)" will be displayed.
⇒
The x after the COM stands for the COM port that is now available (e.g. COM 4).
3. Open the properties for this connection by double-clicking.
4. Switch to Connection properties and select the item "Advanced".
⇒
Here you can now set the desired COM port under "COM port number".
If this port is already assigned to another device (even if it is not currently connected), an
error message appears:
Setting two units on the same COM port is possible in principle, but it must
be ensured that both units are not connected at the same time, otherwise
there will be a conflict!
6. Maintenance and cleaning
Personnel: Skilled personnel
For contact details, see chapter
the operating instructions.
6.1 Maintenance
The interface adapter USB6300 is maintenance-free.
Repairs must only be carried out by the manufacturer.
6.2 Cleaning
Carry out the cleaning process as described below.
1. Prior to cleaning, disconnect the interface adapter from the electrical connections
properly.
2. Clean the instrument with a moist cloth.
Electrical connections must not come into contact with moisture!
WIKA operating instructions, model USB6300
1 "General information"
or the back page of
15
EN
Publicidad
