Publicidad
Idiomas disponibles
Idiomas disponibles
DECK LUBRICATION
The treadmill is pre-lubricated. However, it is recommended to check the lubrication of the treadmill regularly, to ensure an
optimal operation of the treadmill.
After every 2 months of operation, lift the sides of the treadmill and feel the surface of the belt, as far as possible. If traces of
silicon spray are found, lubrication is not necessary. In case of a dry surface, refer to the instructions below.
Only use 100% silicon oil to lubricate your treadmill deck.
To apply lubricant on the belt
Position the belt so that the seam is located in the middle of the plate.
Lift the belt at one side and hold the spray valve at a distance of approximately 15cm to the front end of belt and plate.
Then spray from front to the end. Repeat this process on the other side of the belt. Spray each side for about 4 seconds.
Wait 1 minute to let the silicon spray spread, before starting the machine.
CLEANING
Regular cleaning of the belt ensures a long product life.
Warning: The treadmill must be turned off to avoid electric shocks. The power cord must be pulled out of the socket,
before starting the cleaning or maintenance.
Caution: Do not use any abrasives or solvents. To avoid damage to the computer, keep any liquids away. Do not expose
the computer to direct sunlight.
After each training: Wipe the console and other surfaces with a clean soft and damp cloth to remove sweat residues.
Weekly: To make cleaning easier, it is recommended to use a mat under the treadmill. Shoes can leave dirt on the belt
that can fall beneath the treadmill. Clean the mat under the treadmill once a week.
STORAGE
Store you treadmill in a clean and dry environment. Ensure the master power switch is off and is un-plugged from the
electrical wall outlet.
TROUBLE SHOOTING
Symptom
E00
Safety Key not in position
Communication error (controller
E01
not receives console signal)
E02
Stalling protection
E03
No speed sensor signal
E05
Over current protection
E10
Motor peak
E13
Communication error (console not
receives controller signal)
Cause and Check
Re-locate the safety key into the front of the console
A: Check speed signal wire if connected properly
B: Replace the speed signal wire
C: Replace the driver
A: Re-insert the motor wire or replace motor
B: Replace driver
C: Stop use and ask electrician for trouble shooting
A: Re-insert the speed signal wire or replace sensor
B: Replace driver
A: System protection and re-start the system
B: Adjust transmission part or add lubrication oil
C: Replace motor
D: Replace driver
Adjust the torsion potentiometer to an appropriate
position
A: Replace console
B: Replace driver
16
Solution
Publicidad
