SantaFe ULTRA Serie Instrucciones De Instalación página 6

DEHUMIDIFIER SET UP
4
2. Location Considerations
• Allow sufficient clearance to handle the unit's overall dimensions as well as the necessary return and
supply ductwork to the unit.
• Allow sufficient clearance for filter removal and to prevent airflow obstruction.
• Electrical service access will require the removal of the outside shell. Allow sufficient clearance around the
unit.
• Locate the dehumidifier in an area where the unit's 9 ft. cord can easily reach.
• Locate the dehumidifier in an area where field wiring the control (low voltage) to the unit will be possible.
• A back draft damper is required in the supply duct of the Santa Fe Ultra155/205, especially when connecting
to the supply ducting system. The backdraft damper prevents supply air from counter flowing through the
Santa Fe Ultra155/205 when it is not operating. The dehumidifier's location should be chosen to allow
installation of this accessory if necessary.
• The Santa Fe Ultra155/205 may be suspended with the hang kit or a suitable alternative from structural
members, ensuring the assembly supports the dehumidifier's base in its entirety. Do not hang the Santa Fe
Ultra155/205 from its' cabinet.
• Allow for proper drainage and routing of needed drain pipes.
CAUTION!
REMOVE COMPRESSOR SHIPPING TIE FROM THE UNIT. FAILURE TO REMOVE THE SHIPPING TIE WILL CAUSE
EXCESS VIBRATION TO BE TRANSMITTED TO THE FRAME.
3. Removal of Compressor Shipping Support
• The Santa Fe Dehumidifier uses a compressor to power the refrigeration
system. To protect the compressor and refrigeration system during
shipping, a plastic tie wrap secures it to the unit's frame. Remove the tie
wrap by cutting the tie wrap and pulling from the unit as shown. After
removing tie wrap, insert plastic plugs provided into the holes.
6
Santa Fe ULTRA155/205 Installation & Operation Instructions
The 10" Supply Air Duct (not pictured) is
below the Outdoor Air Intake and the Return
Air Duct. The same amount of clearance
is needed for the 10" Supply Air Duct.
Minimum 20"
Clearance
For Filter
Filter
(Either Side)
A
B
Electrical Service Access
(Either Side)
Without Collars Installed
A
6" Optional Outdoor Air Intake
B 10" Return Air Duct
Drain Port 9' Power Cord
Top View
41 1/2"
With Collars Installed
37 3/4"
Santa-Fe-Products.com | 800.533.7533
A
B
C