Stuart SMP30 Instrucciones De Funcionamiento página 9

The preset programme option allows the default
plateau and ramp rate to be set, as follows:
PRESET PROGRAMME
CHANGE?
EXIT
YES
PROGRAMME 1
PLATEAU 100°C
RAMP 1.0°C/min
CHANGE
Use the upper and lower menu keys next to
"UP" and "DOWN" to select the preset program
number. Use the Enter key to select "CHANGE"
to edit the method.
PROGRAMME 1
PLATEAU 100°C
NEXT
Use the upper and lower menu keys next to
"UP" and "DOWN" to set the plateau
temperature. Holding these keys down for more
than two seconds will increase the speed at
which the value changes until the key is released.
Pressing the Enter key moves the screen on to
the Ramp rate screen.
PROGRAMME 1
PLATEAU 100°C
NEXT
Use the upper and lower menu keys next to
"UP" and "DOWN" to set the ramp rate.
Holding these keys down for more than two
seconds will increase the speed at which the
value changes until the key is released. Press the
Enter key to exit back to the instruments main
menu.
5.8 Printing Results Stored Temperature
1. The stored temperature values from the
YES
NO
TUBE 1 RESULT 1-2 OF 7
TEMPERATURE
RESULT TIME
DONE
UP
DOWN
2. Press the Enter key to select "DONE" to
09:00
EXIT
3. Press the upper menu key next to "PRINT
UP
DOWN
Note:- A hardcopy of the stored
temperatures can only be produced by using
the optional accessory printer SMP30/1. An
example printout is shown in figure 3.
UP
DOWN
Figure 3 (Example Printout using SMP30/1)
Values
previous melt determination can be viewed
by pressing the lower menu key next to
"VIEW LAST RESULTS" in the main menu.
106.2°C 109.3°C
09:00 09:02
display the following screen:
RESULTS" to instruct the instrument to print
the stored temperature values.
112.0°C
UP
DOWN
112.0°C
PRINT RESULTS
VIEW RESULTS
7