Publicidad
Idiomas disponibles
Idiomas disponibles
To use the preferred method of setting the
input gain using a voltmeter or oscilloscope,
begin by turning off the amplifier and
disconnecting all speakers from it. Turn the
gain knob completely off (counterclockwise)
and all crossovers off, or to their least
effective setting. Turn off bass boost. If a
remote bass accessory is connected to the
amplifier, turn it completely on (clockwise).
Ensure all EQ and DSP settings on the
source unit such as bass, treble, fader,
seating position etc are set to linear, flat,
center, or off. Turn on the amplifier. Play a
0dB sine wave through your source unit
and increase the volume to about 3/4
of maximum. Sine wave tracks can be
downloaded for free from KICKER.com
under the "Support" tab. Use the 50Hz sine
wave to set the gain for a subwoofer and
the 1kHz sine wave for full-range speakers.
Set your voltmeter or oscilloscope to
measure AC voltage. Place the voltmeter's
probes on the amplifier's speaker output
terminals. With the sine wave playing, slowly
turn the gain knob clockwise and watch the
AC voltage on the voltmeter increase.
English
35
Publicidad
